Vehicle Fault Setting And Detection Training Platform

. The product is used in the training of the whole vehicle, based on the latest circuit development of the original Volkswagen factory. After the detection box is connected with the vehicle without loss, it can realize the non-destructive connection with the vehicle battery management system, motor controller, AC charging unit, keyless entry system, body control system, body electrical system, gateway, and door computer for the detection and maintenance of the original vehicle. The detection box is convenient for teachers to design and students to measure online signals in real time, and can be selected according to the actual needs of teaching, and the fault point of the detection box is greater than 200 channels, and faults such as open circuit, short circuit, and virtual connection can be set.

2. The vehicle fault setting platform and fault detection box are multi-purpose, which can be used as a fault assessment setting terminal for teachers and a signal measurement terminal for students. It supports signal measurement and fault setting of vehicle battery management system, motor controller, AC charging unit, keyless entry system, body control system, body electrical system, gateway, door computer part.

3. Through the wiring harness plug-in connector matched with the original car plug, the test box can be connected, and the training requirements of vehicle teaching and training assessment can be realized.

4. The back part of the detection box is a mechanical fault setting terminal, which adopts a hidden mechanical fault setting system, and can be set up with open circuit, short circuit, occasional, poor contact, and reverse connection fault of CAN line through the U-shaped connection terminal. It can effectively simulate various phenomena when the system fails, improve the fault judgment ability of the trainees, and effectively protect the efficiency of the equipment.

5. The front part of the detection box is the measurement part for students, which can directly use a multimeter and oscilloscope to measure voltage, current, resistance, frequency, waveform signal, etc. on the panel in real time.

6. The single pin of the detection box adopts the design method of double measuring points, which can effectively help students judge the fault of the component end or the fault of the control unit in the process of fault diagnosis.